Today I will introduce the use conditions of vertical machining centers. Dabai Precision Machine Tool (Jiangsu Co., Ltd.) is a high-tech enterprise specializing in R&D, design, production and manufacturing of CNC machine tools and CNC machine tools. The company adheres to the production concept of high quality and high cost performance to create a high-end CNC machine tool brand.
- Environmental requirements.
The location should be away from vibration sources, avoid direct sunlight and heat radiation, and avoid moisture and airflow. If there is a vibration source near the CNC machine tool, an anti-vibration groove should be set around the machining center. Otherwise, it will directly affect the machining accuracy and stability, cause faults such as poor contact of electronic components, and affect the reliability of the machining center.
- Power supply requirements.
In the general installation machinery workshop, not only the ambient temperature changes greatly, but also the operating conditions are poor, there are many types of electromechanical equipment, and the power grid fluctuates greatly. Therefore, the location of the machining center requires strict control of the power supply voltage. The power supply voltage fluctuation must be within the permitted range and remain relatively stable. Otherwise, it will affect the normal operation of the CNC system of the machining center.
- Temperature conditions.
The ambient temperature is lower than 30 degrees and the relative temperature is lower than 80 percent. Generally speaking, an exhaust fan or cooling fan is installed inside the CNC electric control box. Keep the electronic components, especially the processing unit, at a constant operating temperature or a small temperature difference. Excessive temperature and humidity will shorten the life of the control system components and increase the failure rate. Increased temperature and humidity, and increased dust can cause adhesion and short circuits on integrated circuit boards.
- Use.
It is forbidden to arbitrarily change the parameters set by the manufacturer in the control system. The setting of these parameters is directly related to the dynamic characteristics of each component of the machining center. Only the value of the gap compensation parameter can be adjusted according to the actual situation.
www.dabaicnc.com
